Hello mates, hope u r doing well,
I have a problem with my Huawei Nova Plus AL10 (chineese version), i tried to update the version from 6 toNougat 7 with Huawei firmware finder, when arrived at 100%, it reboots and stucks in Huawei eRecovery (Getting package info failed msg appears).
Than i tried to downlad the official firmware AL10 (chineese version) and flash the phone with sd card (Dload==>Update), it loads and stops in 5% or 49%, the eRecovery and factory reset has never managed to download anything for me, always failed...
NB: Fastboot is working
Any help please neeeeeeeed solution
Fastboot should work,boot into it ( press and hold Volume Down and Power key for a while. You would see a green android.) and make sure you have adb/fastboot drivers installed then try. If that works, you can flash twrp and then a rom
Related
If your device is stucked at honor recovery logo or in a boot loop it is because the recovery of the device is corrupted. You can fix it easily by doing as follows which is very simple.
Procedure:
Step 1. Download the file from here .
HONOR 4X RECOVERY GOOGLE DRIVE DOWNLOAD
Step 2. Extract the downloaded file and copy the entire dload folder (with UPDATE.APP in it) contained in the file we downloaded to the root directory of the Micro SD card.
Step 3. Shut down the phone.
Step 4. Press the VOLUME UP + VOLUME DOWN + POWER Key(simultaneously for few seconds) to power on the phone and enter the Software Upgrade Mode begins automatically. This will start the FIX process on your device.
Step 5. When the progress bar stops(100% upgrade successful), the phone will automatically power OFF and restart.
Thats all.. You have flashed Fresh stock recovery on your Honor 4x.
Has anyone tried this? I am asking this because I have already wasted much data over this and my phone is still stuck on welcome logo only.
honor 4x stuck at fastboot mode
dear sir i have tried your method but its not working i own a honor 4x che1 L04 and while i was flashing it for custom recovery my phone struck at fast boot mode i have been to honor service center but they are unable to solve my problem my contact no is 7379515262 i am really in great problem plzz help me out plzz contact as soon as possible i will be highly grateful to you for your consideration
For CHE1-L04
Dear all,
My honor 4x was stuck in fastboot mode as I was flashing custom Rom in it, so I tried to flash stock rom but it always showed errors, then I went through this site and downloaded this Indonesian stock rom and bingo! My phone is now working normally like before. So maybe flipkart send me the Indonesian honor 4x phone to me labelling che1-L04 or it was my luck.
So go to this site called gizrom dot com
And download the Indonesian stock rom
And follow the steps shown above
This will surely help u guys,
Thank you,
Yogesh Gujarathi
Please provide a working download link.
Thanks.
Hi,
I tried with dload, but no luck... the update got hung at 5%. Please help me
Hi,
I have an unlocked and rooted P8 Lite (ALE-L21) with TWRP 2.8.7.0 (I think that's the version) and I had a google play problem so after trying all solutions that I found it didn't work so i used the advanced wipe function that offers TWRP but accidently i wiped system part so I don't have any OS in my phone and now I have a bootloop. I downloaded a firmware "ALE-L21 V100R001C432B052 Europe channel dual sim" but I didn't know how to flash it because i'm new at huawei phones i was an expert in samsung devices however i don't know how to flash the UPDATE.APP file that I found in the dload folder with TWRP can you help me ? (I can't boot into the bootloader mode i can only boot recovery mode (TWRP) )
Thanks for reading that post ^^
Hello,
You can unbrick your device using this method Unbrick Huawei P8 Lite Ale-L21
Simply boot into bootloader(Plug phone into PC and hold volume down+power button, when phone vibrating release the buttons) when is in bootloader run bat(FLASH-ALL.bat) file in archive
This will install Firmware version C432B052 after that you can update via OTA
Regards
Thanks for replying to this post, I searched a little bit more and I found a software called "HuaweiUpdateExtractor" I extracted 4 files from my UPDATE.APP with that software : system, cust, recovery, boot and then flashed them with fastboot but I can't acces to my bootloader with the 2 volume buttons + power it give me an error so i used TWRP I went to Reboot then Bootloader ^^
Hello. I'm done with my phone, I can't find help on this forum anymore.
I was on Nougat, then I tried to flash Lineage OS, it didn't boot, so I started to look for problem. Ended with bricked phone. Today I finally flashed it and it was okay, but that ROM was buggy, so I decided to go back to stock firmware. I uploaded B130 OEMInfo with custom.bin, got a B130 FW and flashed it through dload. Now my phone is dead, it got black screen. I can't turn it off or go to recovery. No vibrations, no sounds, only black screen. When I connect USB my PC recognizes it and fastboot is working. Tried to flash Nougat firmware again, but it didn't work.
Phone: P9 Lite VNS-L21 (Europe)
My theory - because I didn't used rollback package and just flashed MM OEMInfo, custom.bin and MM firmware through dload it just crashed. Don't really know any reason for it, because before dload it was working.
Found Phone : HUAWEI VNS-L21
Model : Huawei phone in fastboot mode
IMEI : ***
Serial NR. : ***
Firmware : VNS-L21C432B130
IMEI:***
FB LockState: LOCKED
USER LockState: UNLOCKED
unlocked
Battery state: 0
MrDomas said:
Hello. I'm done with my phone, I can't find help on this forum anymore.
I was on Nougat, then I tried to flash Lineage OS, it didn't boot, so I started to look for problem. Ended with bricked phone. Today I finally flashed it and it was okay, but that ROM was buggy, so I decided to go back to stock firmware. I uploaded B130 OEMInfo with custom.bin, got a B130 FW and flashed it through dload. Now my phone is dead, it got black screen. I can't turn it off or go to recovery. No vibrations, no sounds, only black screen. When I connect USB my PC recognizes it and fastboot is working. Tried to flash Nougat firmware again, but it didn't work.
Phone: P9 Lite VNS-L21 (Europe)
My theory - because I didn't used rollback package and just flashed MM OEMInfo, custom.bin and MM firmware through dload it just crashed. Don't really know any reason for it, because before dload it was working.
Found Phone : HUAWEI VNS-L21
Model : Huawei phone in fastboot mode
IMEI : ***
Serial NR. : ***
Firmware : VNS-L21C432B130
IMEI:***
FB LockState: LOCKED
USER LockState: UNLOCKED
unlocked
Battery state: 0
Click to expand...
Click to collapse
Try to charge battery - press a hold Volume+ and connect phone to PC or charger ,hold Volume+ until your phone will turn on ( it may take 5 - 7 minutes ). With a little bit luck your phone will boot into eRecovery , in eRecovery mode you can charge the battery.
I had NOKIA 5 with latest pie update installed
I wanted to flash nokoa 6 ta-1021 rom in it
(I have also successfully installed ta-1000 CN rom in it)
But this this after flashing any older ota update (Dec.2017) I tried to flash with NOST
Although I have unlocked bootloader
But NOST or OST didn't flash and gave an error
Now NOST give me a message that my device is D1C and I am going to flash PLE so confirm it and all data will be erased
Now I confirmed it and it gave me a error of low battery voltage
Now I just boot the phone in recovery mode and power it off so that the phone can get charged
But now it's showing QHSB_BULK in PC
But I just launched NOST and hold the power button
Now my phone is in download mode(thanks to NOST)
BUT the problem is that PC is showing adb interface when the 0hone is in download mode and only adb commands are working
So I typed adb reboot recovery
So I booted in recovery successfully
Now from here I again went in bootloader mode
Now I tried to flash Nokia 5 (ND1) Firmware ,But NOST OR OST both gave an error
I tried ta-1000CN Firmware it also gave an error
Then I tried to flash PLE firmware which I was trying to flash before the phone went in qhsb bulk mode
Now same thing happened when I tried to flash ta-1000 CN firmware
1st-the phone went in qhsb bulk mode because I power off the phone after getting an error
2nd-then using NOST I booted my phone in download mode
Then NOST could only flash ta-1000 model ROMs
So what is it.WHY DOES NOST CAN ONLY FLASH THOSE ROMS WHICH BRICKED MY PHONE A MINUTE EARLY??
AND NOT THE STOCK ONE??
and one thing now I can changed it to Nokia 5 by just flashing any Nokia 5 ota update through applying upadte from sdcard which I downloaded from xda
And now my phone doesn't show POWER BY ANDROID logo while booting
It only shows NOKIA logo
And it doesn't show battery charging icon when the phone is switched off
Other things are working fine(TWRP,magisk)
Except fingerprint data which get lost after flashing any module .
Please read it I know it's very lengthy but suggest me what should I do
Thanks
I had NOKIA 5 with latest pie update installed
I wanted to flash nokoa 6 ta-1021 rom in it
(I have also successfully installed ta-1000 CN rom in it)
But this this after flashing any older ota update (Dec.2017) I tried to flash with NOST
Although I have unlocked bootloader
But NOST or OST didn't flash and gave an error
Now NOST give me a message that my device is D1C and I am going to flash PLE so confirm it and all data will be erased
Now I confirmed it and it gave me a error of low battery voltage
Now I just boot the phone in recovery mode and power it off so that the phone can get charged
But now it's showing QHSB_BULK in PC
But I just launched NOST and hold the power button
Now my phone is in download mode(thanks to NOST)
BUT the problem is that PC is showing adb interface when the 0hone is in download mode and only adb commands are working
So I typed adb reboot recovery
So I booted in recovery successfully
Now from here I again went in bootloader mode
Now I tried to flash Nokia 5 (ND1) Firmware ,But NOST OR OST both gave an error
I tried ta-1000CN Firmware it also gave an error
Then I tried to flash PLE firmware which I was trying to flash before the phone went in qhsb bulk mode
Now same thing happened when I tried to flash ta-1000 CN firmware
1st-the phone went in qhsb bulk mode because I power off the phone after getting an error
2nd-then using NOST I booted my phone in download mode
Then NOST could only flash ta-1000 model ROMs
So what is it.WHY DOES NOST CAN ONLY FLASH THOSE ROMS WHICH BRICKED MY PHONE A MINUTE EARLY??
AND NOT THE STOCK ONE??
and one thing now I can changed it to Nokia 5 by just flashing any Nokia 5 ota update through applying upadte from sdcard which I downloaded from xda
And now my phone doesn't show POWER BY ANDROID logo while booting
It only shows NOKIA logo
And it doesn't show battery charging icon when the phone is switched off
Other things are working fine(TWRP,magisk)
Except fingerprint data which get lost after flashing any module .
Please read it I know it's very lengthy but suggest me what should I do
Thanks
Can you share guide of install nokia 6 ta1021 rom on nokia 5 running android pie
Jitender Baloda said:
Can you share guide of install nokia 6 ta1021 rom on nokia 5 running android pie
Click to expand...
Click to collapse
Mandatory ---Unlocked Bootloader
1st -download any monthly ota update of Nokia 6
Flash it ,it will be aborted
2nd -download Nokia 6 pie ota update from Nokia 6 forum
Flash it
(Both ota updates should be placed on external sdcard)
If this doesnt work then
Flash your phone with Nokia 6 fastboot firmware provided by hikari calyx
It will be done
If it gives an error then boot your phone to recovery
Shutdown from recovery
Now imp.thing is that your phone may be hard bricked at this time
So pc will show it as qhsb_usb bulk
Don't panic
Just open Nost or ost
And press power button
Your phone would boot into download mode
Now you can flash it with ta-1021
Give me your telegram profile name i need to talk on this