Answer, apparently I was using v4 bootloader, thought I was on most recent, but I wasn't. Had a hard time finding newer/current firmwares for my device, but was able to find v5, flashed and went perfectly
So I'm trying to reset my phone as a bad rom flash caused some sort of issue and couldn't get back into twrp "official binaries only"
Find latest firmware for my csc (which was july) doesnt work, I thought it might have been a BL issue as I had the august patch through a custom rom, found a different csc which was from august, and I get the same error
I also no longer get the official binaries only, just a bootloop of "An error has occurred while updating....use emergency recovery function in smart switch" which I also tried, no luck, but I can still get into download mode
Using most recent odin, official cable, updated usb firmware and such and am running as admin. Have tried different ports too, but it always fails at same step
<ID:0/003> Odin engine v(ID:3.1301)..
<ID:0/003> File analysis..
<ID:0/003> Total Binary size: 5716 M
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> NAND Write Start!!
<ID:0/003> SingleDownload.
<ID:0/003> sboot.bin
<ID:0/003> param.bin
<ID:0/003> FAIL!
<ID:0/003>
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
Phone also says SW REV CHECK FAIL (Bootloader) Device 5, Binary: 4 after failed ODIN install
Any Ideas? Thanks
Related
Hi
I have a Galaxy S5 G900A, I tried to Root it but I forgot to put it to debugging Before, and it went into the brick.
I tried to burn him again 5 Android version of AT & TFirmware, but it failed.
I tried to burn it to the full original version of .4.4.2 Firmware includes all the files BL CSC CP and AP, But Odin writes failed.
Samsung Kies files to Recognize it
It has nothing to do?
Wait, Debugging mode you mean Download Mode?
You can try This Method For Unbricking.
Go to Sammobile and download the lastest stock rom, download chainfire and put PA on odin and flash it on Download Mode.
What version of Android was your phone on?
The ATT version of the S5 has a locked/encrypted bootloader, and if you already had lollipop, you can't downgrade to 4.4.2.
You can only flash the most current 5.x roms in ODIN if your phone already has 5.x
Was Installed Android 5.0
I tried to just a Root it at first but I forgot to bring the situation Dibging, then it became bruck
Currently unable to install the Android File AP 5. course in download mode.
Where can I get the full Framework 5 and G900A Android?
<ID:0/003> Added!!
<ID:0/003> Odin v.3 engine (ID:3)..
<ID:0/003> File analysis..
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> SingleDownload.
<ID:0/003> boot.img
<ID:0/003> NAND Write Start!!
<ID:0/003> recovery.img
<ID:0/003> persist.img.ext4
<ID:0/003> system.img.ext4
<ID:0/003> FAIL! (Auth)
<ID:0/003>
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
Hello I recently rooted my phone on 5.1.1 (Lollipop) and everything went well no issues till last night when I tried to install xposed installer and ended up soft bricking (I think) my phone, where it will turn on to the samsung s6 edge + logo and just sit there and won't go any further. I found out how to flash to the original firmware using Odin 3.10.7 and with the stock firmware file.
now I put my phone into download mode and connect it to Odin, put the firmware file into the AP section and hit start.
Once I hit start I get a fail message and this :
<ID:0/003> Odin engine v(ID:3.1100)..
<ID:0/003> File analysis..
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> SingleDownload.
<ID:0/003> sboot.bin
<ID:0/003> NAND Write Start!!
<ID:0/003> cm.bin
<ID:0/003> FAIL!
<ID:0/003>
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
I've tried different firmwares from different sites, different odin verions, USB ports please help
I tried uploading pictures and links to the firmware I used but apparently I need 10 posts before that so if you want to know anything else in order to help please ask.
am non rooted trying to flash a different firmware and I get the same. I remove the OEM lock but cannot flash anything
odin 3.10.7 works
You write SM-G925W8 that´s S6 Edge, not S6 Edge+!!! Try firmware for SM-G928W8!
Hello i have a problem with flashing anything with odin on my Samsung Galaxy S4 9505.
Whenever i try flashing ROM or recovery or whatever, it says this:
<ID:0/003> Added!!
<ID:0/003> Odin v.3 engine (ID:3)..
<ID:0/003> File analysis..
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
Also when i try to boot my phone normally or go to the recovery it says this:
"Firmware upgrade encountered an issue.Please select recovery mode in Kies & try again."
I've downloaded Kies and tried to recover it but it says:
'GT-I9505' does not support initializing.
What i've tried so far:
flashing pit file with and without the rom.Tried multiple odin versions.Tried multiple rom versions.Tried flashing recovery CWM and TWRP.
Also the error i got "Firmware upgrade encountered an issue.Please select recovery mode in Kies & try again." was after i tried flashing official rom 4.4.2 downloaded form Sammobile(first i installed TWRP recovery wiped system data dalvic cache and booted in download mode ). I was previously using latest Android 5.0.1 official.
Is there any hope of unbricking my device?
Have you tried reinstalling your ADB driver?
Honestly, kies sucks. You don't need kies to have ADB driver installed. There is a package that install samsung drivers seperately.
Once you upgraded to a lollipop bootloader you can't just simply go back to a kitkat one. Samsung doesn't allow that.
Try using the back USB ports on your PC. Trust me, it can do wonders.
You could also try Heimdall.
well i think i've advanced abit now i get this:
<ID:0/003> Odin v.3 engine (ID:3)..
<ID:0/003> File analysis..
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> SingleDownload.
<ID:0/003> aboot.mbn
<ID:0/003> NAND Write Start!!
<ID:0/003> sbl1.mbn
<ID:0/003> sbl2.mbn
<ID:0/003> sbl3.mbn
<ID:0/003> rpm.mbn
<ID:0/003> tz.mbn
<ID:0/003> boot.img
<ID:0/003> recovery.img
<ID:0/003> persdata.img.ext4
<ID:0/003> system.img.ext4
<ID:0/003> __XmitData_Write
<ID:0/003> Complete(Write) operation failed.
tried to reinstall the ADB driver and using the back ports.
Also is there any way to flash Official Samsung ROM true a custom recovery?Cuz i just managet to install TWRP recovery on it.
hollydamn i just tried flashing true odin Android 5.0.1 and it worked.But the wifi isn't working it just not letting me turn it on.
Why don't people understand when I say YOU CANNOT DOWNGRADE ?
i didn't downgrade it now i've installed 5.0.1.
simeon112 said:
i didn't downgrade it now i've installed 5.0.1.
Click to expand...
Click to collapse
Yes, but you tried to, even after I explicitly said you can't.
Your WiFi issues might be related to modem/kernel.
You could try flashing a different firmware.
I tied a differed one the wifi works now.Only when i turn on the mobile data and try to go to a random site it says Forbidden.I think i need to wait my carrier to send me the setting for the net...
Anyway THANK YOU very much!! <3
I have an i337m (North American version of s4) and you can downgrade from stock 5.01 to stock 4.4.2. I did this on 3 phones in order to use regionlockaway to sim unlock all three phones. Everything worked, including data and wifi.
I'd like to try a downgrade with a i9505 for curiosity sake but that particular model is not sold by carriers in Canada.
So I wanted to root my phone tonight and thought I was doing everything right, well my phone rebooted and wouldn't connect to my carrier or anything and was checking device status the entire time..
So I decided to reboot and now I am just even more confused.. my phone at the current state is relooping into the recover reboot stage.. so I can't put the phone in USB debugging or anything like some post suggest..
I can get it to download mode but every time I try odin it fails and fails.. I have tried everything to my ability to get this phone to reboot on stock and I just cant seem to figure it out..
I am not to knowledgeable about ROM's and rooting and such and I learned my lesson.
When on the download screen is says at the bottom in red text " SW REV CHECK FAIL : [aboot] Fused 4 > Binary 2
This is the error code I get from Odin when trying to flash back to oem android on my S7 EDGE
<ID:0/003> Odin engine v(ID:3.1005)..
<ID:0/003> File analysis..
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> SingleDownload.
<ID:0/003> emmc_appsboot.mbn
<ID:0/003> NAND Write Start!!
<ID:0/003> lksecapp.mbn
<ID:0/003> FAIL! (Auth)
<ID:0/003>
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
I am more then open to any suggestions I just want my phone back lol
Hi,
My phone is stuck on twrp loading screen. Reboot again lands on the same screen.
I even tried flashing the stock rom(sammobile) via odin but fails everytime
Here is the log:
<ID:0/003> Odin engine v(ID:3.1401)..
<ID:0/003> File analysis..
<ID:0/003> Total Binary size: 4245 M
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> NAND Write Start!!
<ID:0/003> SingleDownload.
<ID:0/003> sboot.bin
<ID:0/003> FAIL!
<ID:0/003>
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
On the Downloading screen:
Odin mode
download speed: fast
system status: official
FRP lock: off
After the stock rom fail via odin, this mesg appears:
KERNAL REV. CHECK FAIL, DEVICE: 5, BINARY: 0
I tried various solutions but nothing seems to work. Please help me!
use correct restore and correct usb cable, oh and another rom
SonyXperiaS said:
Hi,
My phone is stuck on twrp loading screen. Reboot again lands on the same screen.
I even tried flashing the stock rom(sammobile) via odin but fails everytime
Here is the log:
<ID:0/003> Odin engine v(ID:3.1401)..
<ID:0/003> File analysis..
<ID:0/003> Total Binary size: 4245 M
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> NAND Write Start!!
<ID:0/003> SingleDownload.
<ID:0/003> sboot.bin
<ID:0/003> FAIL!
<ID:0/003>
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
On the Downloading screen:
Odin mode
download speed: fast
system status: official
FRP lock: off
After the stock rom fail via odin, this mesg appears:
KERNAL REV. CHECK FAIL, DEVICE: 5, BINARY: 0
I tried various solutions but nothing seems to work. Please help me!
Click to expand...
Click to collapse
Same problem here, did you fix it?
Use the correct bootloader binary, the one you trying to flash is lower then currently installed on your phone.
Try flashing with the version 5 binary roms as displayed in your download mode.