Hello, i was using Skydragon 5.1.1 and it started to become slow, got optimizing apps everytime i restarted the phone, and wanted to flash to LineageOS
Figured I`d update TWRP to latest version, so I got that from their site, version 3.1.1-0 and when I wanted to boot to recovery it would become stuck at the bootscreen. Same thing with any other version over 3.0.2-0.
Used FirstAid to revert to older version of TWRP, and managed to install 3.0.2-0 again and boot to recovery normally.
With this version it seems i cannot install LineageOS because it gives an error.
How do I go about installing Nougat ? Thanks !
First u should install the 3.6.0 Firmware then try install Nougat
cosmin.dark said:
Hello, i was using Skydragon 5.1.1 and it started to become slow, got optimizing apps everytime i restarted the phone, and wanted to flash to LineageOS
Figured I`d update TWRP to latest version, so I got that from their site, version 3.1.1-0 and when I wanted to boot to recovery it would become stuck at the bootscreen. Same thing with any other version over 3.0.2-0.
Used FirstAid to revert to older version of TWRP, and managed to install 3.0.2-0 again and boot to recovery normally.
With this version it seems i cannot install LineageOS because it gives an error.
How do I go about installing Nougat ? Thanks !
Click to expand...
Click to collapse
I have the same problem. Have you found a solution yet?
Related
Hello,
I tried to install the new Nougat rom for jiayu S3, but it was unsuccessful. Phone got soft bricked, but I recovered it with a twrp backup.
My OS is android 4.4.4, and TRWP is 2.8. After installing the new rom , an installation error appeared and phone did not work.
I wonder it it's due to twrp 2.8, but I can't install twrp 3 (S3_h560_TWRP_3.0.2-0). There was an installation error with flashify...
The question is: can I install 7.0 from 4.4? Is it an Android problem, a TWRP issue, or just my clumsiness?
Thank you!
achilipu05 said:
Hello,
I tried to install the new Nougat rom for jiayu S3, but it was unsuccessful. Phone got soft bricked, but I recovered it with a twrp backup.
My OS is android 4.4.4, and TRWP is 2.8. After installing the new rom , an installation error appeared and phone did not work.
I wonder it it's due to twrp 2.8, but I can't install twrp 3 (S3_h560_TWRP_3.0.2-0). There was an installation error with flashify...
The question is: can I install 7.0 from 4.4? Is it an Android problem, a TWRP issue, or just my clumsiness?
Thank you!
Click to expand...
Click to collapse
in short:
To go from 4.4.4 to Nougat you need to go via LP RC5 via flashify using firmware upgrade.
This is because the partition layout is different from KK to LP onwards.
Then you can flash Nougat using TWRP (which will be version 3)
Thank you very much for your answer.
Please forgive me for my ignorance but, which LP ROM should I download? Can I install it via flashify, via TWRP 2.8, o flash?
Thank you again!
You can not use Flashify, you have to do it using Flashtools (with a PC) to go from KK to LP. Download LP 5.1.1 RC 5 from MAD.
fusant said:
You can not use Flashify, you have to do it using Flashtools (with a PC) to go from KK to LP. Download LP 5.1.1 RC 5 from MAD.
Click to expand...
Click to collapse
thanks to correct me, I thought Flashtools was meant
Well, I'm in trouble now... I installed successfully 5.1 in my S3, but when updated twrp 2.8 to 3.0, it did not work, so I can't install Nougat...
Now I have no twrp, and no root. How can I root to install twrp? I can't install superSU neither....
I'm sorry if it has been already answered but I can't find it.
Thanks a lot
I re-installed LP with Flash tools and everything worked right. (In twrp , it says 2.8 version, instead of 3.0, though).
Now I installed Nougat, and everything is ok.
Thank you for your excellent job!
Hello,
I've installed twrp on my lg g2 802. Using twrp i tried to install lineageos, but on reboot the screen remains black. I see the monitor on but nothing happens. I have to force the reboot. I can still go into recovery but i don't understand where is the problem.
I already tried to wipe everything, and i installed latest nightly of lineageos (no gapps).
Da you have an idea?
I have this same exact problem. I hope a solution is out there!
i installed from a kitkat. Maybe this can be a problem? Should i install lineage from a lollipop?
Flash this
https://forum.xda-developers.com/lg-g2/development/boot-g2-hybrid-bootstacks-t3183219
I got LineageOS to work!
It was a long grind of reading various posts on here and looking up other info on google, but I finally got my phone to run LineageOS.
The three things that I think are key are:
Making sure your phone is starting off with kitkat. I wasn't able to root my phone with lollipop. Stumproot, towelroot, and ioroot all didn't work. Once I downgraded to kitkat, I rooted successfully with ioroot.
After getting TWRP, updating it to 3.1.0. I had to first get an older version and then flash 3.1.0
Change the bootloader to kitkat if it isn't on it already. I used Bootloader Changer.
emilio84music said:
i installed from a kitkat. Maybe this can be a problem? Should i install lineage from a lollipop?
Click to expand...
Click to collapse
Yes u need lp bootstacks. Or you can simply get to the stock lollipop using flashtool and then flash lineage os
Thank you for support. Now it works
Its a shame.
7 years unlocking bootloaders, installing CWM or TWRP or Philz recovery, flashing rom after rom, not even one device bricked, and today, i messed up, i hope its not bad.
So the short version of what i did is that i flashed twrp.img trough and older version of twrp and now it wont boot into twrp, it says that it failed to verify the recovery image or something like that, and my laptop wont recognize the cellphone, the cellphone boots into the latest Havoc rom but without Gapps and without root because i did not install it beforehand, when in bootloader mode it just says that it could not recognize the device.
The long version is that i had Resurrection Remix, obviously an unlock bootloader, magisk etc... everything was fine until today that i tried to install Havoc, the installation went well but i found out that ambient display was not working, someone told me that the previous version of Havoc did not had that problem so i tried to flash it but it bootlooped for like 1hr, so i read that the version of TWRP provided by the OP was the way to get it to work, i downloaded the .img file and flashed it trough TWRP and tried to install Havoc again but i was stuck in a bootloop, so i flashed the latest Havoc build so i could download the latest version of twrp, i did not flash Gapps or Magisk because i was going to re flash the rom and then flash Gapps and magisk, so i downloaded TWRP and flashed trough TWRP and thats when the sh$& hit the fan, now it wont boot into TRWP and my laptop wont recognize the device, neither on android nor in bootloader mode.
So, thank you guys in advance for your help, tomorrow im going to try on a computer at my work and see if its my computer and if not, well, ill have to se what you geniuses come up with. thank you so much again.
Info:
Rom build number: opm6.171017.030.h1 or 20180811 android 8.1.0
TWRP: i started with 3.2.2-0 then i downgraded to 3.2.1-0 and the one that messed up everything was 3.2.3-0
By the way, I have a full twrp backup of when my phone was stock, (but no way to use it) T_T
The problem is this:
I want to root my j500m with magisk via twrp but I would like to know if I can root with my version of android 5.1.1 if there is no problem, or I have to upgrade to 6.0.1 to do the process?
Another thing, that when I install the twrp on my device with android 5.1.1 loads everything well but at the time of powering it clears the operating system of the phone and does not turn on completely, it only stays in the samsung logo and I have to flash the rom of stock to solve it but the recovery returns to stock. The version of the recovery that was installed was 3.0.0-0. I would like to know if it is because I am doing it with android lollipop and I should do it in marshmallow or no matter what version of android you have. Thank you.
use this twrp.and first install Magik apk and flash lastest magisk. zip https://forum.xda-developers.com/galaxy-j5/development/recovery-recovery-pro-galaxy-j5-2015-t3728264
And there's no need to update to Android 6 for root
Thanks, but now I have another problem, I just wrote it in the last message of the forum, if you could help me.
Your twrp version is old 3.0.0.0
download this version 3.1.1.1 official
https://eu.dl.twrp.me/j5lte/twrp-3.1.1-1-j5lte.img.tar
and flash use odin.
Thanks friend, I have updated to marshmallow and I have installed the recovery 3.2.1-1 with aroma support, and I have rooted with magisk, now everything is fine.
I have an N9005 device, it comes with default stock rom (5.0 lollipop), the problem is I tried to install the last TWRP version but it doesn't boot into twrp, I can only install old twrp version 2.8.7.0, and I cannot manage to get it to boot into last twrp version, as I want to install an android 12 rom and can't do it unless I have latest twrp version.
What could i do to install an android 12 rom coming from stock rom?
Install LineageOS on hlte | LineageOS Wiki
wiki.lineageos.org
If something doesn't work, you must describe it precisely, showing messages or screens.
ze7zez said:
Install LineageOS on hlte | LineageOS Wiki
wiki.lineageos.org
If something doesn't work, you must describe it precisely, showing messages or screens.
Click to expand...
Click to collapse
There's no message or screen, if i flash twrp 3.7 using Odín or adb it directly boots normal when i try to boot into recovery, but if I flash old twrp versión (2.7) it works fine
You don't need to install version 3.7 right away. Do a trial with twrp-3.5.0_9-0-hlte.img first, but flash it directly from TWRP, not through Odin. Use the IMG option to flash the recovery partition.