ive just realised the green call/send button on side of mda pro doesn't work i think it stopped after rom update but not sure as its a new phone and i didn't test it beforehand !!! any ideas anyone?
I have a Cingular 8125, and for some reason the Green Phone button to dial, and the Red phone button to hangup have stopped working. Would anyone know of a fix to this issue?
Thank you so much in advance !!!
After playing around, I figured it out.. but for anyone else that might have this issue Here's what I found to be the problem.
I had IPBlue's Cisco Callmanager softphone installed, I un-installed it and presto ! the buttons worked again !!!
I got back my tattoo from service beacause when you click the menu button or the beck button the volume goes down by it self and sometimes keybord shows up with no reason...any way again the same thing is happening......
Did anyone encounter such problems?
Could anyone give me any advice?
Thank you very much!!!!
OptimuM-Z1 said:
I got back my tattoo from service beacause when you click the menu button or the beck button the volume goes down by it self and sometimes keybord shows up with no reason...any way again the same thing is happening......
Did anyone encounter such problems?
Could anyone give me any advice?
Thank you very much!!!!
Click to expand...
Click to collapse
I have never heared of such problems with a HTC Tattoo, but in my experiance devices that act that way are not working properly.
My advice to you would be to send it back to service or to create an RMA (Return Merchandise Authorization) with the device Manufacturer.
Good Luck.
so I just noticed the lights for my hardware buttons are stuck on, happens from the moment the phone turns on, and nothing changes it (though they seem to dim slightly) I've tried reflashing the phone (using mdj cyanogen 2.7, nand with magldr 1.12)
I tried searching and havent seen anything like this. Only thing I can think is maybe it got a little wet(?) while I was recording video during a snow storm here, but nothing else seemed wrong, just got home and noticed it. Any ideas?
I have the exact same problem. I've flashed back to the original windows mobile rom and the problem is still there! I've searched and yet to find the solution. Anyone got any ideas?
Check to see if you have a voicemail - you may have read it but closed VM before listening to all the message, it can on occasions do this - it I'm right just ring your phone leave a fresh VM then go into VM and listen to the whole message
Thanks for the reply, but no dice on this one. I tried the voicemail thing and I have no voicemails.
To clarify it's the bottom 5 buttons (call, home, windows, back and power) that are constantly lit up. Even when the phone goes on standby those buttons stay lit. I'm looking to see if there's an app that can just shut them off.
I got the same problem. My hd2 got some water on it and the problem started. The hardware keys now getting dim but not getting completely off. There is no other problem
Please help.
same problem on my father htc click
Ok guys try the bottom of post 4 here:
http://forum.xda-developers.com/showthread.php?t=926507
I use that rom (the 1.7) version and the fix works
johnerz said:
Ok guys try the bottom of post 4 here:
http://forum.xda-developers.com/showthread.php?t=926507
I use that rom (the 1.7) version and the fix works
Click to expand...
Click to collapse
Thanks, I will try the rom.
But do u really think its a rom problem ? The keys light were working fine before the water hazard in the same existing rom. Besides the problem is also there when u are in the boot menu of MAGLDR or Clockwork menu.
any updates from anyone? On miy HD2 the vol up, start, back & end call key don't respond to any presses but seem to be active. Calls will randomly end, vol up acts as if the button is kept pressed!
Help!
Hi guys,
A little bump in this thread, but is there already found a solution for this problem?
After a hard reset and replacing the digitizer of my htc HD2, the buttonlights remain on. Even when the phone gets in standby mode.
I'm using cyanogenmod 7. (bought it like this. Didn't put android on it myself)
After the hard reset and digitizer replacement there also came another problem.
When pushing the windows logo (key 158) the volume up button also reacts (key 115). Thesame problem occurs when pushing the dial button. With that key (231), key 114 (volume down) reacts.
So when i want to open a menu or make a call the volume goes up or down.
Do you guys think I screwed something up when replacing my digitizer or is it just an software issue caused by the hard reset?
All right guys, it was an hardware failure.
I reopened my htc and checked all the connectors and (re)placed some of the yellow tape. After the reassembly, my phone just works as it should. All problems are solved.
My HTC HD2 also got the keys stuck after only a week of use. T-Mobile is sending me a replacement phone today.
Is this a common problem? I'm afraid it may happen again.
Hey guys I'm having same issue. Going to try opening up and check connectors.
I just got this device and 10 minutes of fiddling with it the back button stopped working wtf? anyone else have this problem??
I don't know that I'd ever heard of anyone having an issue with the capacitive buttons.
I'm sure you've already tried restarting your streak. You can call Dell and seek support with it. They also respond to posts on their facbook page.