Any body know where/if theres an internal fuse on the elf? - Touch GSM General

Hi, just bought this touch/elf after being informed that it wouldn't charge and then died as battery went, flat. I'm struggling to see the internal fuse, anybody know where she's at??
I've repaired an s200 and an m700 by replacing the fuses so I'm hoping this will be the same............................we'll I live in hope.
Also who makes/supplies the covers for these.
THX

same problem here
Hello guys,
my htc touch (elf) is dead. not booting at all. Guess it mite a fuse problem as mentioned earlier. plz help me to boot it..

Related

Need help!

Hi, have a problem on my xda2, my screen keeps on blinking and flickering, its like there's a cricket sound. my speaker also does not work.
it just happend while i was playing.
can you help how to resolve it or do you know any tech person that diagnose or repair it.
thanks.
den
my unit was fixed already, they said that its the mainboard that has a problem, and it will cost 35 thousand pesos if there's no warranty.
i'm just curious, can anybody tell what causes this problem.
according to the repair center, it can be cause by a corruption of a file or the rom (is it rellay possible?)... or if the unit is inside a tight pocket always.... or the unit was wet by moisture.
guys, i need your inputs before i do something with my unit, just confused a bit coz i want to upgrade my xdaII himalayan to wm2003se by xda2jojo version.
thanks in advance
I would try hard reset and removal of battery first. If that doesnt help I would flash with a standard rom.
flash it with 1.72.00 WWE original ROM,try it since u have nothing to loose(u already have no warranty) :wink: ,then if the problem persists,take it to the service center(if it's a hardware issue)....good luck

broken charging connector... need a new/used mainboard.

My 2i's charging connector broke. Sent it back to O2's repair centre and they specifically said that the mainboard has to be changed. Anybody here know of any thrifty way to get hold of a mainboard or a something similar? Any help is greatly appreciated. Thanks.
Vincent
fixed same problem my self
Hi ,
I received a similar device from a collegue.
His charging connector was completely severed from his mainbord.
I opened the device and solderd it back on my self. Device is working again.
If you have te same problem maybe it's cheaper to find someone who can do this for you then looking for a replacement mailboard.
I have to say I had to try it 2 time because the connections where really tiny.
GreetZ
Rob
exactly...tiny...
You're right, it's very small, plus I have fat fingers. Well, maybe I should get someone to do it for me. I was hoping for a short cut solution and not too expensive one as well. I might try that after the holidays..

Dead Hermes...need help

My Hermes just died today. No type of LED while charging even without the battery in. I was wondering about switching the fuse off of the motherboard (A solution I found after some searching through the forum). Where do i purchase the fuse? any suggestions? has anyone ever done the switch before?
I have some experience with motherboards and I have opened my Hermes before (once for an LCD swap, once for a keypad problem).
Thanks for any help in advance!
Unless you are pretty experienced in surface mount soldering and electronics, you will probably fry your Hermes.

[Q] No service after screen replacement

Hey guys, I hope you can help me with this:
I cracket the screen on my Lg G2 (D802), so i bought a new screen to fix it. Screen is working fine, but now it got (almost) no service I opened it several times already to check all connectors, antenna cables and so on but can't figure out the problem... Has anyone had similar issues and knows how to fix this?
Thank you very much!
hi. i Have that same prob. after lcd replace... no service - try wipe and fresh instal rom - form me it's working .

My Lg g2 have a red flashing led but not start

Hello everyone,
I'm here because i've a little problem with my d802. Few months ago, i've break my motherboard (i've shorted the capacitors with a screwdriver.. -_-). But now i've buy a new motherboard for my lg g2, she was tested and she work.
I've an idea but not sure if it's the problem : I've don't use my phone and the parts during a long time, may be the battery was drained at 100% and she die ?. anyway, have you got a solution for this problem ?
please help me
Thank you in advance, sorry for my english if it's not 100% understanding but i'm french and don't use english all the time.
Thanks for reading me
edit : the led is blinking, she not stay red.
8 times-pause-8times-pause
I've charge the phone during 5-6hours now
the motherboard have never be rooted
no water damage
May be i've fined the issue
Hello guys,
Hi guys
Today I went to the mobile repair shop to establish a diagnosis.
the guy changed the battery, the phone started , until then, I was happy !
When , just after the boot logo I could see a fabulous " white noise " on my screen .
In my head, I said " if the phone starts, is that it has a charged battery , the problem was not the battery.
Then I remembered this topic: http://forum.xda-developers.com/showpost.php?p=62401112&postcount=13
And I say that it's just me flex cable is dead, what do you think ?
If you think it may be the case this will encourage me to order the part .
To tell a little about my life, I have been fortunate to have the free diagnosis , I did just order the parts myself : p
And voila, if anyone have a problem, that is a way for you.

Categories

Resources