Call Problems with Elf - Touch GSM General

Till yesterday, my elf was working fine. But suddenly, my elf has started blocking outgoing and incoming calls. Whenever I make a call, it tried to dial and then show the "Call Ended" message. There's a problem with incoming calls too. When a caller calls my number, he gets the "All lines in this route are busy" message while my elf lights up, gives a single ring and then cuts the call. The call shows up as a missed call. What is the problem?
The funny part is the GPRS/EDGE works fine without any problems. Sync with PC also works fine. While sending a message, sometimes I get a "Message cannot be sent" message. Then resending it (2-3 times) works. Incoming SMS is also working I think.
Note:
1. Call barring is NOT active.
2. No new applications have been installed for the past 3 months.
3. Have never performed a ROM update. It has the default HTC ROM which came with the phone.
4. Shows Full signal strength
Please help as this is causing a lot of problems.

am also facing this same prob...it was working fine till yesterday but donno wat happ all of a sudden??anybody there 2 help us??

may be airtel is not working properly, check with airtel

hey no...i tried with 2 other phones and it worked perfectly....some prob with my Elf.

hey anybody found a solution to this call problem with Elf?

hi
hi,
Iam using HTC touch (P3450) & i use to have same problem with airtel. Then i switched my provider from Airtel to vodafone & now its working fine.
Have you tried doing a reset.

i tried everything except changing 2 another n/w....i gave it 4 service and they said tht PCB has 2 be changed...

finally got my PCB replaced and my phone is working fine now...

Related

M3100 cannot make outgoing calls

I've recently bought a SIM-free SPV M3100, however I cannot make outgoing calls using my old 2G SIM. The phone accepts incoming calls with no problem, and is able to send texts as normal. But whenever I try to make an outgoing call, it comes back with the "beep beep beep" network busy and call ended status. I've done soft and hard resets to no avail.
The phone works fine as I have tried my wife's Orange 3G sim and outgoing calls can be made okay. I've also tried my 2G SIM in my wife's M5000 and that works fine making outgoing calls okay.
I've spoken with Orange and they seem to think there shouldn't be a problem and that 2G SIMs are supported. They've reflashed my SIM but still no success.
Has anybody seen anything similar?
You can try, hardreset, then just after you setup your security stuff (eg screen where it ask you for the phone's PIN), perform a soft reset. This will prevent the EXTROM stuff to be installed. Just incase some of the settings there are messing your thing. Worth a try.
Thanks for the advice - tried that, but still no luck unfortunately

Trinity locks up when answering/ending call

I have a colleague with a HTC P3600 GER, he complains that sometimes when he presses green button to answer a call or red button to end the call the device becomes unresponsive and he has to soft reset the device.
Is this a known problem?
Problem 3G -> GSM
Hi !
Same issue with my device but only in one condition:
I get an incoming call within a mixed 3G/GSM provider network (A1-Vodafone Austria) - i press the green button and my Trinity switches from 3G to G - the call seems to be answered but i cannot hear anything.
----->I wrote the following error description to HTC:
Massive problem answering phone calls in mixed GSM/UMTS network.
My P3600 works fine when the display shows 3G Network. Answering a call works fine by pressing the left phone button. The display closes the caller bubble and switches to the connected status and shows caller and time and so on. But every time the phone is connected to only GSM radio station - display shows "G" beside the antenna icon i cannot answer a single call. Pressing the left phone button results in showing the white bubble with caller information and nothing happens - the call doesnt start the calling party always hear the normal beep tone while waiting for pick up of the phone. In this circumstances i cannot hear anything from speaker and also cannot end the call by pressing the right phone button (hangup) - the software of the P3600 stops responding and the caller bubble is frozen at the display. When the call is discontinued by the caller the P3600 resets to normal activity waiting for a call and showing a missed call !! This happens at every GSM call - about 10 t! imes since yesterday !! It is very important for me that i can answer calls in both network connection modes because the austrian provider A1/Vodafone has mixed environment all over the country. The receipton of GSM while the problem comes up is always more than 2 or 3 bars on antenna display.
Hope that there is some possible solution for this problem.
ROM Software Version is:
1.16.407.2 (German)
Setting for network provider is:
Automatic
Band selection is:
Auto
Auto
Many thanks in advance !!
Gerhard from Austria
----->The answer from HTC was:
Hello
This seems to be a very strange issue that you are experiencing and something that we have not heard of before.
Does this occur every time that you receive a call in a non-3G area?
I would recommend that you perform a Hard Reset on the device. This will restore the device back to the factory software settings. This will also remove all settings, contact , calendar information as well as any files and SMS.
Once this has been performed I would ask you to test if this has resolved your issue. If this has then you should experience no more issues. If this does not solve your issue then I would recommend that you contact your local repair center, details below, to arrange a repair of your device.
+ 43 (0) 508115555
[email protected] <mailto:[email protected]>
Yours sincerely
Dan Mackie
[email protected]
http://www.htc.com
----->The Hardreset does not fix the problem :-(
Still waiting for a firmware upgrade ....
Gerhard
Since Uprade to Radio ROM 1.41.00.11 (http://forum.xda-developers.com/showthread.php?t=304006) i have no more problems with answering phone calls !!!
Hope the Radio ROM will be included in an official ROM Upgrade from HTC soon.
Gerhard

Can't make or receive calls, just get 3 beeps

The phone I have is a T-mobile MDA Compact that has been network unlocked.
The problem is that it is unable to make or receive normal calls. The symptoms vary across networks, with vodafone being the most functional. The symptoms are as follows.
----
Tesco Mobile SIM: - no service.
----
T-Mobile SIM: Connects to network and shows a signal, but no call functions work.
----
vodafone SIM (ASDA): Connects to network, shows a signal, can send and receive text messages, can make 999 calls.
Can't make or receive normal calls:
When trying to dial out the display goes from "dialing" to "call ended" and three quiet beeps can be heard, the dialed phone never rings.
If called from BT landline the caller simply hears "Error" and callers from other mobile phones hear a variety of different tones (engaged, beeps etc)
If the phone is switched off, the callers get the usual "the phone you are calling is not available" message.
------
The phone has a CheckMend certificate to show that it is not lost or stolen, and T-Mobile have confirmed that the IMEI is not barred on their network.
-----
While attempting to fix this:
I have reflashed the phone with several ROMs and updated the radio from 1.12 to 1.13, but the original problem remains unchanged.
I Have E-mailed HTC technical support with a description of the problem but as yet have had no reply.
If any one is able to shed any light on this I would be very grateful.
similar problem, but i can send or receive SMS, but when i try to call or answer after cca 10sec it cut the line and show a sign of searching for signal...
flashed new ROM, same problem, chanhge automatic to manual, same...
is it a software or hardware problem, i can try to open and clean a dust (in one service said that could be a problem) which cause a bad contact with internal antenna
hi, did you get this problem sorted? i have the same thing with my spv m700, cant believe its hardware though as all other functions ar great
thanks

Ipaq 614c Sms cannot be sent

Hi everyone , i have a problem with my ipaq 614c i'm using wm 6.1 here is my problem : when i want to send out a sms it takes around 10 mins and then it displays "Your text message cannot be sent.", but the weird situation is that if i make calls in this period not just 1 call if i talk for 10 mins or if i call and hang up and so on for 10 minutes the sms is sent.I'm using Vodafone RO and the sms service center is set ok.Please Help!!
Same problem here.
MMS sending and SMS-receiving works fine, just as all other services do (email, internet, etc.).
Only sending SMS does not work. Messages remain in the outbox for about 10 minutes and the error message appears.
Have you tried my solution ? making calls in those 10 minutes ?
i need to make like 3 of them to successfully send a sms. Ps. And i believe that all sms that i recive are delayed 20 30 minutes.
I had that problem too, the same with Vodafone RO. Try the sim card in a different phone and if it is working try a factory reset.
My topic is here http://forum.xda-developers.com/showthread.php?t=417783
I believe this problem is caused by having an old SIM card. My Vodafone UK SIM worked fine in my ipaq 6915 (WM5) and in many other phones, but when I got my 614c, it seemed that this model was unable to read the SMSC (short message service delivery centre) number out of the SIM, so SMS messages could not be sent. I found that my SFR (Vodafone France) SIM card worked fine which made me think it must be the Vodafone UK SIM.
When I got a new SIM from Vodafone UK, the problem disappeared.
You can verify whether this is indeed your problem by going to Settings > Phone > Services > Voice Mail and Text Messages > Get Settings. If "Text messages service center" is set to null, or another value that is not correct for your network, you have the same problem as I did. (You will probably find you are unable to set this field manually - it is read from the SIM.)
So i said that if i make calls i can send the sms ..i tried to get the settings i got them and worked but same problems with sending i also tried the factory reset several times nothing as well tnx for suggestions if you have more i will be pleased to try them all.

Cannot send SMS but can recieve

Hi there from the title its pretty self explanatory
im from melb, aus
got a "Telstra" Touch HD but im using another different companies Sim card in it
i can make and recieve calls
i did a "Clear storage" but nothing helped there
i read about something referring to "At commands" or "at commanders"
but nothing found doing a search
thanks
same problem with me.. i send a message and after some time it says message could not be sent.. sometime i receive the message with a delay too.. i checked my sim in other phone, there it is fine.. the problem is only in touch
Similar problems connecting to internet and making phone calls
I occasionally have the problem sending texts but more frequently cannot make a phone call or data connection. I have found that if I go into the Comm Manager and set the phone to Airplane Mode and then back to Phone mode that this works 9 times out of 10. However, this is not a very satisfactory or permanent fix. If anyone has a more permanent solution I would be interested in hearing it. I live in the UK and am on the the 3 network. I have a feeling it may be an issue with my provider and not the phone but the help staff at 3 are useless. Thanks!
hey there
sorry for late reply
but i had my service provider reset my messaging service and it worked by the end of the day.
not sure why it was the case. too complicated for me to try and explain probably.
peace

Categories

Resources